Signage & Lettering

Polymer Composite Installation

Table 1-Polymer Composite Substrate Preparation
Table 2-Polymer Composite Installation Procedures
Polymer Composite Installation Figures

TABLE 1 - POLYMER COMPOSITE SUBSTRATE PREPARATION
Download: PDF 278kb DWG 3.2mb
Substrate Condition Preparation
Concrete, Masonry, Stucco on Block, Stucco on Lathe Clean Untreated No preparation required.
Dirty, Form Oil Residue Clean Surface with detergent & water then rinse thoroughly and/or scour with a wire brush.
Painted, Sealed Thoroughly wash away dirt, dust, and chalking paint.
Smooth Surface (Tilt-up, FRC Board) No preparation required.
Polystyrene Board   Apply glass fiber cloth & waterproof coat of polymer stucco according to manufacturer's instructions before applying medallion.
Interior Gypsum Board, Two-Coat Plaster New Unpainted No preparation required.
Painted, Dirty Remove loose or flaking paint.  Clean as per adhesive manufacturer's specifications.
 
TABLE 2 - POLYMER COMPOSITE INSTALLATION PROCEDURES
Download: PDF 261kb DWG 3.2mb
Substrate Procedure
Exterior Concrete, Masonry, Stucco on Block, Stucco on Lathe Prepare surface as indicated in Table 1. Predrilled pieces may be fastened with screws and back plates or toggle bolts to wall.
Polymeric Stucco over Polystyrene Board Stainless steel anchor screws must penetrate through polystyrene panel to structural substrate base. Use approved waterproof caulk adhesive at point of penetration to prevent water from entering screw hole.
Interior Gypsum Board, Two-Coat Plaster Prepare surface as indicated in Table 1. Apply construction adhesive to piece and press into place as per adhesive manufacturer's instructions. Predrilled pieces may be fastened with screws and anchors or toggle bolts to wall.

Note: Tables 1 and 2 assume wall is structurally sound, stable and weather tight.

Note: Ultimate connection design is the responsibility of Building Design Engineer, Architect or otherwise responsible person charged with the connection design.

Warning! Failure to follow these instructions or to install product in an insecure or unsafe manner can result in property damage, serious injury or death. Personal safety equipment required for installation. See Polimer Composite Installation Specs 3.2 A.

Installation Figures Polymer Composite installation figures. Installation Figures